These are instructions on how to embroider the Cutwork
Lace Rose Corner design. The design is available in 2 sizes for the
large (5" x 7") and mega (6" x 10") hoops.
We also show how to make a doily using the motif. On the photo you can
see the doily with the motif for a mega hoop and a greeting card with the
motif for a large hoop.
One of the advantages of the design is that you embroider each pattern
separately and then incorporate them into a larger project - this eliminates
the possibility of ruining your project if something goes wrong during
embroidery.
You will need fabric for the applique, water soluble mesh and embroidery
threads.
Step One: To embroider this design, hoop a layer of water soluble
mesh. Start embroidering. The machine will embroider the outline of the
design and stop.
Step Two: Cover the outline with fabric and start the machine.
The machine will embroider the outline of the lace and stop.
Step Three: Take the hoop from the machine. With a pair of sharp
scissors cut away the fabric in the areas shown on the picture.
Step Four: Return the hoop to the machine and finish embroidering.
Step Five: Wash away the stabilizer and neatly spread on flat
surface and leave to air dry. Press if needed.
Making the Doily
Here is an example of how to make a doily using 4 motifs. The finished
size of the doily with mega hoop motifs is 15 1/2" x 15 1/2" .
Embroider 4 motifs following Steps One through Five.
Lay them out in a closed shape as shown. Sew them together at points where
they touch. You'll get a square lace frame.
Place the frame over a piece of fabric and pin in place.
Straight stitch (the length of the stitch should be 1mm) the inner
outline of the lace frame to the fabric as shown in red. Both in the needle
and in the bobbin, use thread of the same color as the embroidery.
With a pair of sharp scissors, cut away the excess fabric close to
the straight stitch you just made.
Return to your machine and, using dense zig zag, stitch over the raw
edge of the fabric. Both in the needle and in the bobbin, use thread of
the same color as the embroidery.
