This small and very handsome quilt features the designs from the Trapunto
Quilting Block Set for large (5" x 7") hoop.
The finished size of the quilt is about 15 1/2" x 21 1/2". |
|
For the project you will need:
-
Sulky Puffy Foam, 2mm thick (see http://www.sulky.com/puffyfoam/)
-
Quilter's tape,
-
Patterned fabric for the sashing and borders,
-
Solid cotton fabric for the base,
-
Solid light-weight cotton (such as batist) for the topping,
-
Light-weight tear-away stabilizer,
-
Rayon or polyester embroidery threads.
You will also need batting, fabric for the backing and binding. |
|
Embroidery:
|
| First make the embroidery of the trapunto designs as described
in the instructions. |
|
Cutting:
|
| Trim the embroidered pieces to 6" x 6" squares.
Out of the patterned fabric, cut
four strips measuring 2" x 6"
two strips measuring 2" x 15 1/2"
three strips measuring 2" x 19
1/2". |
|
Assembly:
|
Using the 2" x 6" strips and the embroidered squares, assemble 2 strips:
square - strip - square - strip - square |
|
| Stitch one of the 2" x 19 1/2" strips between the two strips. |
|
| Stitch the remaining 2" x 19 1/2" strips to the left and right edges
of the quilt. |
|
| Stitch the 2" x 15 1/2" strips to the upper and lower edges of the
quilt. |
|
|
Quilting:
|
| Now place the backing on a flat surface (table) face down. Cover with
batting. Spread your working piece over it.
Pin all three layers together with 1" pins. Start quilting. Quilt in
the ditch around the squares. Then quilt the sashing and the broders. |
|
| After the quilting is finished, press the work from the back side with
heavy steam and square the work -- all corners should be 90 degrees and
opposite sides should be of the same length.
Finish the raw edges with the binding.
Attach a sleeve, if you want to use the quilt as a wall hanging. |
| Here are some close-ups of the embroidery: |
|
|
|
|
|
The quilt is ready. Enjoy!
|
|
Happy Stitching!
|
|
Back to Trapunto
Quilting Block Set.
|
|
Back to the Projects Page
|
