Cutwork Lace Coasters

These are instructions on how to embroider the designs from the Cutwork Lace Flower Doily Set. The designs are available in 3 sizes for the large (5" x 7"), mega (6" x 10") and commercial (over 10") hoops.

The finished size of the coasters are about 5" x 5" (large), 6" x 6" (mega) and 7 1/2" x 7 1/2" (commercial).

You will need fabric, water soluble mesh and embroidery threads.

Step One: Hoop 2 layers of water soluble mesh. Tighten the hoop! Start embroidering. The machine will embroider the outline of the design and stop.

Step Two: Cover the outline with fabric and start the machine. The machine will embroider the outline of the lace and stop.

Step Three: Take the hoop from the machine. With a pair of sharp scissors cut away the fabric in the areas shown on the picture - around the outline and inside the closed areas.

Step Four: Return the hoop to the machine and finish embroidering.

Step Five: Wash away the stabilizer, neatly spread on flat surface and leave to air dry. Press if needed.

The doily is ready. Enjoy!

Happy Embroidering!

Back to the Cutwork Lace Flower Doily Set