Cutwork Lace Morning Glory Doily

These are instructions on how to embroider the Cutwork Lace Morning Glory Doily. The design is available in 3 sizes: for the commercial (8" x 8"), mega hoop (6" x 10"), and for the large hoop (5" x 7").

Commercial Hoop: Size: 199 x 199 mm Stitches: 58073 Colors: 1 Mega Hoop: Size: 149 x 149 mm Stitches: 37732 Colors: 1 Large Hoop: Size: 129 x 129 mm Stitches: 30809 Colors: 1

You will need fabric, water soluble mesh and embroidery threads.

We recommend to use water-soluble mesh, such as Vilene. Vilene D0102 is a non woven dissolvable stabilizer which is imported into the US, is sold in large rolls and is sometimes repackaged under different brand names.

Some of these brand names are Fabri-Solvy by Sulky, Avalon Plus by Madeira, Wash-Away, and Aqua Magic.

40-weight embroidery polyester threads are preferred for the project.
Cotton thread is not suitable because the embroidery will be too bulky.
Rayon thread is softer and more sensitive to the chemicals in the water-soluble mesh. We do not like to use rayon thread for cutwork lace projects.

Please note: ALWAYS make a test stitch-out on scrap before you make a stitch-out on the real item.

Doily:

Step One: Upload the file into the machine. Hoop 1-2 layers of water-soluble mesh. Start the machine. It will embroider a circle over the stabilizer.

Step Two: Cover the circle with a piece of fabric and start the machine. The next color will embroider the outline of the flower motif inside the circle.

Step Three: Take the hoop from the machine. With a pair of sharp scissors cut away the fabric inside the outline in the places shown on the picture below and around the circle.

Step Four: Return the hoop to the machine and finish embroidering.

Rinsing away the stabilizer is also an important step, because the lace can be stretched or distorted if this is done incorrectly. We recommend to use a foam board and stainless pins.

Cut away the excess stabilizer close to the stitches. Take your time and carefully pin all the edges to the board.

Now place the board into a bowl with luke-warm water. Leave the board in the water for at least half an hour. Change the water a couple of times.

Take the board out of the water and leave to air dry. Do not unpin the lace until it's completely dry.

Press, if needed.

Happy Embroidering!

Back to Cutwork Lace Morning Glory Doily