Feather
FSL Doily is a set of 2 Freestanding Lace Machine Embroidery Designs.
The parts of the Feather
FSL Doily are embroidered in the same way as ornaments, so please read
the General Guidelines
first.
|
|
Some points to remember from the General Guidelines:
Use Vilene water soluble stabilizer;
Use the same thread for the upper and bobbin to get two-sided embroidery.
DO NOT embroider several designs in one hoop. |
Here are instructions on how to make the doily using the
Feather
FSL Doily Set.
You will need Vilene water soluble stabilizer, and embroidery threads.
The diameter of the finished doily is 15 1/2". |
|
Step One: Embroider part #1 once, and part #2 eight times.
Use 2 layers of Vilene-type water-soluble stabilizer. To get 2-sided
embroidery, use the thread of the same color for both the needle
and bobbin. Rinse the stabilizer and leave to air dry. |
| Impotant Note: It's very important to use as small a hoop as
possible. E.g. if your design is for a small hoop, use the small hoop,
not the large one; if your design is for a large hoop, use large, not mega.
Do not try to embroider several freestanding lace designs in one hoop.
This is because all water-soluble stabilizers stretch, and in a bigger
hoop, it's going to stretch more. This can lead to the design falling apart
after the stabilizer is dissolved. It's always better to embroider one
part at a time. |
| |
| Step Two: Press all parts with steam. On your working table,
lay out the designs as shown on the picture below. Thread a needle with
the same thread that you used for the embroidery and stitch together the
parts in the places marked with red.You will get a lace frame. This has
to be done manually. |
|
|
The doily is ready. Enjoy!
|
|
|
| |
|
Back to Feather
FSL Doily Page
|
|
Back to Projects Page
|
